Product Data Sheet Show all documents

SikaGrout®-214

GENERAL PURPOSE SHRINKAGE COMPENSATED CEMENTITIOUS GROUT

SikaGrout®-214 is a cement based, 1-component, ready to mix, free flowing expansion compensated low shrinkage general purpose grout.

  • High final strengths
  • Shrinkage compensated
  • Fluid consistency
  • No segregation or bleeding, allowing good adherence and load transfer
  • Easy to use (ready to mix powder)
  • Fast strength development
  • Non-corrosive. It does not contain metallic elements or chlorides
Product Data Sheet Show all documents

Usage

SikaGrout®-214 is used as free flowing pouring mortar suitable for grouting:
  • Heavy equipment / machine bases
  • Base plates
  • Filling cavities, gaps and recesses
  • Anchoring bars
 

Advantages

  • High final strengths
  • Shrinkage compensated
  • Fluid consistency
  • No segregation or bleeding, allowing good adherence and load transfer
  • Easy to use (ready to mix powder)
  • Fast strength development
  • Non-corrosive. It does not contain metallic elements or chlorides

Packaging

30 kg bags

Colour

Grey powder

Product Details

Product Information

Composition

Cement, selected fillers and aggregates, special additives

Shelf life

6 months from date of production

Storage conditions

Store properly in dry conditions in undamaged and unopened original sealed packaging
Technical Information

Compressive strength

1 day

28 days

~ 18 MPa

~ 50 MPa

 

Application

Application Information

Mixing ratio

3.0 to 3.3 litres per 30 kg bag

10% to 11% litres water by weight of powder

Layer thickness

Maximum 100 mm

Flowability

~ 110 %, with 11% water

(ASTM C-1437 - ASTM C-1107)

Ambient air temperature

+ 5°C minimum/ +30 °C maximum

Substrate temperature

+5 °C minimum/ +30 °C maximum

Consumption

Yield

1 bag yields approximately 15 litres of mortar
Application steps

MIXING

SikaGrout®-214 can be mixed with a low speed (< 500 rpm) hand drill mixer to avoid entraining too much air. Mix only full bags for best results.

Pour the recommended water in a suitable mixing container. While stirring slowly, add the powder to the water and mix thoroughly at least for 3 minutes adding additional water within the mixing time if necessary to the maximum specified amount to adjust the grout to the required consistency.

 

APPLICATION

Remove excess water from substrate surface e.g. with clean sponge, until surface is dark matt in appearance without glistening (saturate surface dry). Surface pores and pits shall not contain water. Let the grout stand for ~5 minutes to release air entrained by mixing. Pour grout into the prepared openings using a sufficient pressure head to mantain a continuos flow of grout. Make sure that enough material quantity is mixed. Ensure air displaced by the mortar can easily escape.

CURING TREATMENT

Keep visible exposed grout surfaces to a minimum. Protect the fresh material from premature drying using appropiate curing method e.g. curing compound, moist textile membrane, polythene sheet, etc.

CLEANING OF EQUIPMENT

Clean all tools and application equipment with water immediately after use. Hardened/cured material can only be mechanically removed.

 

Documents